New bootloader for Gigablue UE and SE
flash so then on you can eg. OPENMIPS active Irishman to 2.0 flash support to splash, do not need more flash burn.bat at e2,
will support the activation period splash flash and e2 after reboot
times and test report,
Description:
- Bootloader (cfe and burn.bat) on stick
- Normally do box
- Insert the rear USB port on the USB flash drive
- Power to Box
- Wait until flashed bootloader (purple LED flashes)
- Box goes high
- New firmware for SE or UE (folder gigablue without burn.bat) copy it to another USB flash drive
- Normally do box
- Insert the rear USB port on the USB flash drive
- Power to Box
- For UI now comes to notice that the "OK" button on the box must be available at SE on display "conf"
- Press the OK button on flash box and starts (LED flashes purple)
- For UI new message is displayed, which will now be flashed on the display is at SE "Load"
- Wait until box restarts
- Splash screen comes
- Boot image is
will support the activation period splash flash and e2 after reboot
times and test report,
Description:
- Bootloader (cfe and burn.bat) on stick
- Normally do box
- Insert the rear USB port on the USB flash drive
- Power to Box
- Wait until flashed bootloader (purple LED flashes)
- Box goes high
- New firmware for SE or UE (folder gigablue without burn.bat) copy it to another USB flash drive
- Normally do box
- Insert the rear USB port on the USB flash drive
- Power to Box
- For UI now comes to notice that the "OK" button on the box must be available at SE on display "conf"
- Press the OK button on flash box and starts (LED flashes purple)
- For UI new message is displayed, which will now be flashed on the display is at SE "Load"
- Wait until box restarts
- Splash screen comes
- Boot image is
Gigablue SE
Gigablue UE
0 comentários:
Post a Comment